High
Volume - Dewatering Pump
|
|
 |
| 1. Semi-open, Ductile Iron impeller with replaceable/adjustable wearplate increases wear resistance when pumpage contains abrasive particles. | 1. Commercial, industrial dewatering and construction site drainage. |
| 2. Double inside mechanical seals with silicon carbide faces, (both top and bottom) running in an oil filled chamber and further protected by a lip seal running against a replaceable, 420 stainless steel shaft sleeve, provides for the most durable seal design available. | 2. Effluent transfer |
| 3. Highly efficient, continuous duty air filled, copper wound motor with class E, B and F insulation, minimizes the cost of operation. |
3. Decorative waterfalls and fountains |
| 4. Built in thermal & amperage sensing, protector prevents motor failure due to overloading or accidental run - dry conditions. | 4. Raw water supply from rivers or lakes |
| 5. Double shielded, permanently lubricated, high temperature C3 ball bearings fated for a B-10 life of 60,000 hours, extend operational life. | |
| 6. Top discharge, flow-thru design enables operation at low water levels for extended periods. |
 |
 |
 |
| Discharge Size | 3", 10" Npt (100, 200mm) |
Available in all Stainless
Steel
|
| Horsepower Range | 3 - 30Hp. (1.5 - 11Kw) | |
|
Performance Range |
||
| Capacity | 100 - 3100Gpm (.37 - 11.9 cubic metre/ min) | |
| Head | 30 - 100Ft. - 100 Ft. (2.4 - 30.47 m) | |
| Maximum water temperature | 104F. (40C) | |
|
Materials of Construction |
||
| Casing | Cast Iron | |
| Impeller | Ductile Cast Iron | |
| Shaft | 420 Stainless Steel | |
| Motor Frame | Cast Iron | |
| Fasteners | 304 Stainless Steel | |
|
Mechanical Seal |
||
| Upper Seal |
Silicon Carbide / Silicon Carbide |
|
| Lower Seal | Silicon Carbide / Silicon Carbide | |
| Elastomers | NBR (Nitril Buna Rubber) | |
| Impeller Type | Semi-open & Enclosed (KRS10M) | |
| Solids Handling Capability | Screen size | |
|
Motor Nomenclature |
||
| Type, Speed, Hz | Air Filled, 1800 Rpm, 60 Hz. | |
| Voltage, Phase | 208/230/460/575 V.., 3 Phase | |
| Insulation | Class E (3 - 7.5 Hp.) | |
| Bearings | Pre-lubricated, Double Shielded | |
| Accessories | Submersible Power Cable 49' (14.9 m) | Length as Required |
| Operational Mode | Manual | |
