Residual
Water - Dewatering Pump
 |
 |
| 1. Semi-open, Ductile Iron impeller with replaceable/adjustable wearplate and built in check valve allows for residual water removal down to 3/64 of an inch. | 1. Residential, commercial, industrial residual drainage. |
| 2. Double inside mechanical seals with silicon carbide faces, (both top and bottom) running in an oil filled chamber and further protected by a lip seal running against a replaceable, 403 stainless steel shaft sleeve, provides for the most durable seal design available. | 2. Basement sump pump (does not require a sump) |
| 3. Highly efficient, continuous duty air filled, copper wound motor with class E, insulation minimizes the cost of operation. |
3. Decorative waterfalls and fountains. |
| 4. Built in thermal & amperage sensing, protector prevents motor failure due to overloading or accidental run - dry conditions. | |
| 5. Double shielded, permanently lubricated, high temperature C3 ball bearings rated for a B-10 life of 60,000 hours, extend operational life. | |
| 6. Top discharge, flow-thru design enables operation at low water levels for extended periods. |
 |
 |
 |
| Discharge Size | 3/4 Npt (19 mm) |
Available in all Stainless
Steel
|
| Horsepower Range | 1/2 Hp. (.4Kw) | |
|
Performance Range |
||
| Capacity | 5 - 32Gpm (.018 - .12 cubic metre/ min) | |
| Head | 3 Ft. - 34Ft. (.91 - 10.3 m) | |
| Maximum water temperature | 104F. (40C) | |
|
Materials of Construction |
||
| Casing | Cast Iron | |
| Impeller | Ductile Cast Iron | |
| Shaft | 403 Stainless Steel | |
| Motor Frame | Aluminium alloy | |
| Fasteners | 304 Stainless Steel | |
|
Mechanical Seal |
||
| Upper Seal |
Ceramic/Carbon (1Hp) |
|
| Lower Seal | Silicon Carbide / Silicon Carbide | |
| Elastomers | NBR (Nitril Buna Rubber) | |
| Impeller Type | Semi-open, solids handling | |
| Solids Handling Capability | Screen opening | |
|
Motor Nomenclature |
||
| Type, Speed, Hz | Air Filled, 3600 Rpm, 60 Hz. | |
| Voltage, Phase | 115 V.., 1Phase | |
| Insulation | Class E | |
| Bearings | Pre-lubricated, Double Shielded | |
| Accessories | Submersible Power Cable 16' (4.87 m) | Length as Required |
| Operational Mode | Manual | |
