Low
Level - Dewatering Pump
 |
 |
| 1. Semi-vortex urethane Rubber impeller with butadiene rubber and nitrile rubber casing increases wear resistance when pumpage contains abrasive particles. | 1. Residential, commercial, industrial dewatering and site drainage. |
| 2. Double inside mechanical seals with silicon carbide faces, (both top and bottom) running in an oil filled chamber and further protected by a lip seal running against a replaceable, 403 stainless steel shaft sleeve, provides for the most durable seal design available. | 2. Effluent transfer. |
| 3. Highly efficient, continuous duty air filled, copper wound motor with class B insulation, minimizes the cost of operation. |
3. Decorative waterfalls and fountains. |
| 4. Built in thermal & amperage sensing, protector prevents motor failure due to overloading or accidental run - dry conditions. | 4. Raw water supply from rivers or lakes. |
| 5. Double shielded, permanently lubricated, high temperature C3 ball bearings rated for a B-10 life or 60,000 hours provide for extended operational life. | |
| 6. Top dischage, flow-thru design enables operation at low water levels (3/16") for extended periods. |
 |
 |
 |
| Discharge Size | 2'' Npt (50 mm) |
Available in all Stainless
Steel
|
| Horsepower Range | 1/2 Hp. (.4Kw) | |
|
Performance Range |
||
| Capacity | 15 - 63Gpm (.056 - .23 cubic metre/min) | |
| Head | 6 Ft. - 34 Ft. (1.82 - 10.3 m) | |
| Maximum water temperature | 104 F. (40 C.) | |
|
Materials of Construction |
||
| Casing | Butadiene Rubber and Nitrile Rubber | |
| Impeller | Urethane Rubber | |
| Shaft | 403 Stainless Steel | |
| Motor Frame | Aluminum alloy | |
| Fasteners | 304 Stainless Steel | |
|
Mechanical Seal |
||
| Upper Seal | Ceramic / Carbon | |
| Lower Seal | Silicon Carbide / Silicon Carbide | |
| Elastomers | NBR (Nitril Buna Rubber) | |
| Impeller Type | Semi-vortex, solids handling | |
| Solids Handling Capability | Screen Size | |
| Bearings | Prelubricated, Double Shielded | |
|
Motor Nomenclatur |
||
| Type, Speed, Hz | Air Filled, 3600 Rpm, 60 Hz. | |
| Voltage, Phase | 115 V., 1 Phase | |
| Insulation | Class B | |
| Accessories | Submersible Power Cable 32' (9.75 m) | Length as Required, (69' Max) |
| Operational Mode | Manual | TS-301 Float Switch |
