All
304 SS - Dewatering Pump
 |
 |
| 1. Semi-open, 304 Stainless steel impeller with replaceable/adjustable wear plate increases wear resistance when pumpage contains abrasive particles. | 1. Residential, commercial, industrial dewatering and site drainage. |
| 2. Double inside mechanical seals with silicon carbide faces running in an oil filled chamber and further protected by a lip seal running against a replaceable, 304 stainless steel shaft sleeve, provides for the most durable seal design available. | 2. Chemical spill containment. |
| 3. Highly efficient, continuous duty air filled, copper wound motor with class E insulation, minimizes the cost of operation. |
3. Decorative waterfalls and fountains. |
| 4. Built in thermal & amperage sensing, protector prevents motor failure due to overloading or accidental run - dry conditions. | 4. Raw water supply from rivers or lakes. |
| 5. Double shielded, permanently lubricated, high temperature C3 ball bearings rated for a B-10 life or 60,000 hours provide for extend operational life. | |
| 6. top discharge, flow-thru design enables operation at low water levels for extended periods. |
 |
 |
 |
| Discharge Size | 2' Npt (50 mm) |
Available in all Stainless
Steel
|
| Horsepower Range | 0.5 1.0 Hp. (0.4 - 0.75Kw) | |
|
Performance Range |
||
| Capacity | 20 - 90 Gpm (.075 - .34 cubic metre/min) | |
| Head | 7 Ft. - 45Ft. (2.1 - 13.7m) | |
| Maximum water temperature | 130 F. (54.4 C.) | |
|
Materials of Construction |
||
| Casing | 304 Stainless Steel | |
| Impeller | 304 Stainless Steel | |
| Shaft | 304 Stainless Steel | |
| Motor Frame | 304 Stainless Steel | |
| Fasteners | 304 Stainless Steel | |
|
Mechanical Seal |
||
| Upper Seal | Silicon Carbide / Silicon Carbide | |
| Lower Seal | Silicon Carbide / Silicon Carbide | |
| Elastomers | NBR (Nitril Buna Rubber) | |
| Impeller Type | Semi-Open, solids handling | |
| Solids Handling Capability | Screen Size | |
| Bearings | Prelubricated, Double Shielded | |
|
Motor Nomenclature |
||
| Type, Speed, Hz | Air Filled, 3600 Rpm, 60 Hz. | |
| Voltage, Phase | 115/230 V., 1 Ph, 208/230/460V, 3Ph | |
| Insulation | Class E (1/2 - 5 Hp), F(7.5 - 15 Hp.) | |
| Accessories | Submersible Power Cable 32' (9.75m) | Length as Required |
| Operational Mode | Manual | TS-301 Float Switch |
